Sunday, July 29, 2012

Week ending 8th Jul 2012 - Podcast, videos, upcoming events, first flights and news

For the week ending 8th Jul 2012

Podcasts

Articles / News

Videos

Upcoming Events

 

First Flights

4 Jul 86 - Dassault Rafale 
5 Jul 42 - Avro York 
8 Jul 47 - Boeing 377 Stratocruiser 

Tuesday, July 24, 2012

Lesson 27 : 3rd Solo

19 February  
Warrior III VH-TAX

Weather QNH 1015; Wind: 4kt NW, Temp: 20c 
Runway 35R

Time for some more solo circuits.  I need 2 hours of Solo circuits (plus another theory test) before I can be signed off for "Area solos".  After stuffing up my landings during the last 2 lessons it would also be an opportunity for some much needed landing practice.




Friday, July 20, 2012

Lesson 26 : Forced Landings

14 February 
Warrior III VH-TYD

Weather QNH 1019; Wind: light S, Temp: 22c 
Runway  17L

Today I would be learning all about forced landing.  One of those things you need to learn but you never actually want to do. The goal of a forced landing is to get onto the ground safely, if the plane can fly again - it's a bonus. 



We start the lesson with the normal routine; Preflight, run up, take off and fly out to the training area.  It had been about 5 weeks since I'd last went to the training area so I need to think hard to remember all the steps - climb to 2500 on downwind leg, change squawk code and radio frequency once outside Class D airspace.

The basic steps for a forced landing are 
  1. Come to best glide speed (73kts)
  2. Select a suitable landing area and position the plane.
  3. Try to restart the engine 
  4. Mayday call
  5. Passenger Brief
  6. Prepare for the landing
The first step seems relatively easy.  If above 73kts use the excess speed to gain height.  If below 73kts stick the nose down to gain 73kts.  However, a couple of things make this a bit harder  - 1) the need to quickly trim the plane at 73kts, this reduces the workload for the other steps,  2) while trimming get started on steps 2 &3.

Step 2 should be easy as I'm over hundreds of large flat paddocks - However it's this step that caused me the most problems and leads to me trying to rush the following steps.  With so many options I became fixated with finding the "best" paddock.   I'd learn later to just pick an area with "ok" paddocks and start heading that way while you get through steps 3, 4 & 5.   (more on this later)


Step 3 -  Two rounds of checks to try and restart the engine.  First the basic CFMS checks (same as EFATO). Carb Heat on, Fuel pump On Change Tanks, Mixture rich, Magneto on both, Master switch On.
  
Next the more detailed Trouble shooting check list - FMOST.
  • F Check the fuel levels, check fuel pump on, change tanks if required
  • M Mixture learn then back to rich, (Just simulate when practicing)
  • O Oil Temperature and Pressure,
  • S Switches. Magneto Left, Right and back to both, (Simulated)
  • Throttle.  Throttle to idle and back to full.  
Hopefully the engine will have restarted at some point, in which case time to head for the nearest airport and land.  If it didn't, then we are going to be making a forced landing and it's time to let someone know.


Step 4 the Mayday call. This part was easy Mayday, Mayday, Mayday, Tango Yankee Delta, Tango Yankee Delta, Tango Yankee Delta, <location>, <Problem>, < Number of people of board> < what I'm going to do>.  Also need to turn on the ELT (Emergency Locator Transmitter) and squawk 7700.

We can't restart the engine so we are going to have to land, someone hopefully knows we are in trouble so time to get everyone on the plane ready - Step 5 The Passenger Brief.  "Glasses off, Remove sharp object, pen, keys from your pockets and place on the floor.  Seat belts tighten and prepare to brace."  Front passenger get a special bit about opening the door  "unlatch just before we land and once we stop open and exit and quickly as possible."


Now all that is left is the landing. So continuing on from Step 2.  While we have been going through steps 3,4 & 5 and maintaining 73kts, we also need to be refining the landing spot and get the plane into position. The goal is a standard left hand circuit which puts at 1500ft AGL abeam the landing point on a downwind leg.

Ideally the landing paddock should be 400+m long, aligned with the wind direction on the ground,  Have a good approach (no/low trees, no power lines, buildings etc.), Clear of stock, ditches, fences, plough lines, rocks etc,  Doesn't slope downhill too much, Near help (houses, road etc). 


The last preparation is a prelanding checks BUSH.  Brakes, undercarriage, Switches off (Master off only once electronic flaps are deployed) fuel off, Harness secure (Hatch unlatched once at ~100feet).  Aim is to complete this during base or early final.

Once Jason has demonstrated all this it was my turn.  Even though I read the brief before the lesson and have gone through the check list dozens of times in my head, I quickly start having problems.

  1. Trying to find a paddock and maintain 73kts quickly chew up most of my brain power.  (I fell like I'm back doing my first circuits)
  2. 5-6 paddocks look OK as a good landing paddock but none are prefect.  So I start second guessing myself which wastes valuable time.  
  3. I'm to close to the paddock on downwind.  This makes my turn from downwind around to final quite steep and I end up losing height or overshooting. 
  4. I need to practice my side-slips some more.  I not yet comfortable slipping to lose extra height if required.  (I would have overshoot a couple of time - which is better than undershooting, providing I can slip to lose the extra height)

After 4 attempted forced landing we headed back to Moorabbin.  Jason assured me I'll get plenty of practice over the coming lessons and during my Navigation exercises (after my GFPT) .


VH-TYD Piper Warrior III  - Forced Landings - 1.3hrs Dual, (Total time 28.3 hrs)

 
View Forced Landings 14/02/2012 11:46 AM in a larger map

Thursday, July 12, 2012

Week ending 1st Jul 2012 - Podcast, videos, upcoming events, first flights and news

For the week ending 1st Jul 2012

Podcasts

Articles

Videos

Upcoming Events

First Flights

Tuesday, July 3, 2012

Lesson 25 : More Circuits (9)

6 February  
Warrior III VH-TXH

Weather QNH: 1007, Wind: W ~10kts, Temp: 18c 
Runway  31R

After a stormy, 35C day yesterday, today was looking like a nice flying day - clear, cool day - but with a crosswind.  So, rather than head out to the training area for a lesson on forced landings, we took the opportunity to practice crosswind landings.




All I can say is - I needed the practice.  The transistion from crabbing to side-slipping the last few feet before landing is ugly.  When I got it right (a couple of times) it felt great.  Most of the time however, I'd use the rudder to kick us straight then feel I need to worry about the round out & flare. 

Rather than use opposite aileron to balance the yaw/roll, I'm centring the rudder and using no aileron.  The result is the plane starts drifting across the runway centre line.  It made for some very interesting landing.

We managed to get in 8 circuits before it was time to call it a day and while I felt I made some progress I can see I need to practice crosswind landings whenever I can.


VH-TXU Piper Warrior III  - crosswind circuits - 1.1hrs Dual, (Total time 27.0 hrs)


View Crosswind Circuits - 6 Feb 12 in a larger map

Monday, July 2, 2012

Week ending 24th Jun 2012 - Podcast, videos, upcoming events, first flights and news


Besides flying there are plenty of other aviation related things to keep you busy,  Here are just a few from the week ending Jun 24th 2012.

Podcasts

Video 

Articles

Upcoming Events


First Flights

    Sunday, July 1, 2012

    Week ending 17th Jun 2012 - Podcast, videos, upcoming events, first flights and news


    Besides flying there are plenty of other aviation related things to keep you busy,  Here are just a few from the week ending Jun 17th 2012.

    Podcasts

    Video 

        Articles


          Upcoming Events


          First Flights